Camera Accessories
FREE SHIPPING to Peninsular Malaysia for orders over RM39.00
Camera Accessories
Camera Accessories

To help customers use different camera modules on different boards, Arducam offers many camera accessories for multiplexing, adapting and extending.


We have multi-camera adapter boards that can accommodate several cameras on a single board, CSI to HDMI adapters that enable you to extend camera signals through standard HDMI cables, and some other adapters for Pi zero to use standard cameras.

Sort by
Show result
  • Onboard LDO regulators for 2.8V and 1.8V
  • Single 3.3V power input
  • 2.54mm (0.1 inch) standard pin out
  • Open source project supported
  • Active array size: 2592 x 1944
  • Power supply:
    • Core: 1.5VDC + 5% (internal regulator)
    • Analog: 2.6 ~ 3.0V
    • I/O: 1.7 ~ 3.0V
  • Sony 8MP IMX219 Sensor
  • Optical Format: 1/4 inch
  • Data Format: RAW8/RAW10
  • View Angle: 75 Deg. (Horizontal)
  • Interface: MIPI CSI-2 2-lane
  • IR Sensitivity: IR Sensitive, without IR Filter
  • Sensor type: IMX219
  • Optical Format: 1/4 inch
  • Data Format: RAW10
  • View Angle: 75 Deg. (Horizontal)
  • Interface: 2-Lane MIPI
  • IR Sensitivity: Visible light, Integral IR Filter
  • 1/2.3" optical format
  • RGB Bayer pattern
  • 14MP 4608 x 3288 MT9F001/002 sensor
  • 1.4 x 1.4 um Pixel size
  • 6.3fps at full resolution
  • Reserved microphone and headphone jack for audio or GPIO signals 
  • Three additional solder pads are available (same signals as headphone jack) 
  • HDMI cables can be up to 10 meters
  • Support up to 4 ArduCAM mini SPI cameras
  • 4 cameras work simultaneously
  • Onboard SD/TF card storage
  • Additional power supply input
  • Well mate with Arduino
  • Accommodate up to 4 ArduCAM mini boards
  • Onboard SD/TF card storage (only available for Arduino)
  • Additional power supply input
  • Compatible with Arducam MIPI
  • Support with Arduino, Raspberry Pi and BeagleBone Black boards