Autobotic Sdn Bhd | Empowering Makers Marketplace

Hi peace, thanks for contact with us. Regarding the issue that you mention seem like you having a problem for initialized the SDCARD. We already run a test to this item in our center, the result that we get for initialization was successful. During our Test:- - format the SDCARD using SD Formater. - Change this line const int chipSelect = 4; to const int chipSelect = 10; in the 'cardinfo.ino' code - Make sure the baud rate is set to 57600 baud " Serial.begin(57600); " - the brand of SD Card used is SanDisk 16GB Ultra A1 Micro SD Card - if you having a trouble please visit this link. http://tinkbox.ph/sites/tinkbox.ph/files/downloads/Keyes%20-%20Data%20Logging%20Module%20%28rev%201.0%29.pdf You can contact our support at Customer Services : +6011 1005 3015. Thank You.

Hi, bought this card, but SDCARD initialized failed. SDCARD is 256 MB FAT16 verified working good and readable in card reader. just use simple example of 'cardinfo.ino' in arduino IDE, and CS pin set to 10. can you help please?

The brand is Tongling from China, slightly different from what has been display in this webpage. I receive it with NO COM NC relay on my Raindrops sensor board.